Lennox EL296UHV Error Code E 295: Indoor Blower Motor Temperature Too High
What Does Code E 295 Mean?
Error code E 295 on the Lennox EL296UHV means the indoor blower motor's temperature climbed too high and its built-in thermal protector tripped, shutting the motor down to prevent damage. The SureLight integrated control reports this as E 295 and clears it after the blower demand is satisfied and the motor cools enough for the protector to reset.
On this model the blower is a variable-speed ECM motor, which contains its own electronic module in addition to the windings and bearings, so it has several ways to overheat. The most common is restricted airflow: a severely clogged filter, closed or blocked registers, or collapsed ductwork makes the motor work harder against resistance and build heat. Worn bearings add friction and heat, and an aging motor or a stressed electronic module can run hot on its own.
E 295 is the overheating counterpart to E 292, where the same blower cannot start at all — often for the same underlying bearing or motor problems, just at a different stage. It is also related to E 291 on this control. A motor that has tripped its thermal protector is showing stress that tends to worsen, so once the easily checked airflow causes are ruled out, evaluating the bearings and amp draw and deciding whether the motor needs replacement is technician work.
What You'll Notice
- The blower stops mid-cycle and warm air stops coming from the registers
- The seven-segment LED shows E 295
- The blower may restart after a cooldown, then trip again later
- The motor may sound strained or you may notice a hot smell near the furnace
- Airflow from the vents seems weak before the motor shuts down
How This Is Diagnosed
A technician starts with the airflow causes that most often overheat the motor: a clogged filter, closed or blocked registers, and restricted or collapsed ductwork that forces the blower to work against high resistance. Clearing those is the first step because they raise motor temperature quickly.
If airflow is adequate, they measure the motor's amp draw and check the bearings for wear, since a motor drawing high current or fighting worn bearings will overheat on its own. Based on those readings they determine whether the ECM motor needs replacement.
When to Call a Professional
This code involves components that are not homeowner-serviceable, so have a licensed HVAC technician diagnose and repair it. Keep in mind:
- The blower keeps stopping mid-cycle and restarting after it cools
- E 295 recurs even after the filter is replaced and registers are opened
- The motor sounds strained or smells like it is overheating
- You notice weak airflow before the motor shuts down
- The furnace also logs E 292 or E 291 in the history
Frequently Asked Questions
Is a clogged filter really enough to cause this?
Yes. Restricted airflow from a severely clogged filter, closed registers, or collapsed ductwork is one of the most common reasons the blower motor overheats, because it forces the motor to work harder and build heat.
How is E 295 different from E 292?
E 295 means the blower motor overheated and tripped its thermal protector while running. E 292 means the blower could not start at all. They often share underlying causes like worn bearings, but occur at different points.
Does the code reset itself?
It clears after the blower demand is satisfied and the motor cools enough for the thermal protector to reset. But a motor that keeps overheating is under stress and will likely trip again until the cause is corrected.
✓ Verified against manufacturer service manual — March 2026